How long before I can drive on a new concrete driveway?

Walk on it after 24 to 48 hours. Park passenger vehicles after 7 days. Keep heavy trucks, dumpsters and equipment off for a full 28 days while the concrete reaches design strength.

Can you pour over my existing driveway?

Rarely a good idea. An overlay inherits every crack and movement problem under it. We almost always recommend removal and replacement, and we handle the tear-out and haul-off.

Do you widen existing driveways?

Yes. Extensions, turnarounds, RV and boat pads and third-car additions are a large share of our residential work. We match joint lines and finish so the addition does not read as an add-on.

Should I seal my new driveway?

Sealing is optional in this climate but it helps against de-icing salt and oil staining. Wait at least 30 days, then reseal every few years if you want that look maintained.

Concrete Driveways

New driveways, replacements and extensions poured to hold up to Middle Tennessee freeze-thaw and heavy vehicles.

Call (615) 207-6787 Free written estimate

A driveway is the largest single piece of concrete most homeowners will ever buy, and it is the first thing anyone sees when they pull up to your house. Williams Concrete Services pours new driveways, tears out and replaces failing slabs, and adds turnarounds, parking pads and extensions throughout Gallatin, Hendersonville, Portland, White House and the rest of Sumner County.

Nearly every driveway failure we are called out to repair traces back to the same three things: a base that was never compacted, concrete placed too wet, and control joints that were cut too late or spaced too far apart. We build the driveway from the dirt up so those failures never start.

What's included

4" to 6" thick slabs, thickened where trucks and RVs turn
Compacted crushed-stone base with proper drainage fall away from the home
Saw-cut control joints placed within hours of finish, not days
Broom, exposed aggregate, stamped border and smooth-trowel finishes
Tear-out and haul-off of the old driveway included in replacement work

How thick should a residential driveway be?

Four inches over a properly compacted base handles passenger cars and light trucks. We recommend five to six inches with rebar anywhere a dually, RV, boat trailer or concrete truck will cross. Paying for two extra inches once is far cheaper than replacing a cracked slab in six years.

Base preparation is most of the job

Middle Tennessee clay swells when wet and shrinks when dry. We undercut soft spots, bring the subgrade up with crushed stone, and compact in lifts. A flat, stable, well-drained base is why a driveway stays flat — and it is the part some contractors skip because you never see it after the pour.

What this costs

Driveway pricing depends on square footage, thickness, reinforcement, tear-out, site access and finish. We quote the whole job in writing after an on-site measure — no per-foot guessing over the phone.

Get your number: (615) 207-6787

Concrete Driveways questions

How long before I can drive on a new concrete driveway?: Walk on it after 24 to 48 hours. Park passenger vehicles after 7 days. Keep heavy trucks, dumpsters and equipment off for a full 28 days while the concrete reaches design strength.
Can you pour over my existing driveway?: Rarely a good idea. An overlay inherits every crack and movement problem under it. We almost always recommend removal and replacement, and we handle the tear-out and haul-off.
Do you widen existing driveways?: Yes. Extensions, turnarounds, RV and boat pads and third-car additions are a large share of our residential work. We match joint lines and finish so the addition does not read as an add-on.
Should I seal my new driveway?: Sealing is optional in this climate but it helps against de-icing salt and oil staining. Wait at least 30 days, then reseal every few years if you want that look maintained.

Get a free concrete driveways estimate

We'll measure on site, walk you through the options, and put the whole scope in writing.

(615) 207-6787